Lenze i550

Restart or stop communicaon
The 0x2380 (P508.00) parameter can be used to restart or stop communicaon. Oponally it
is also possible to reset all communicaon parameters to the default status.
A restart of communicaon is required aer changes of the interface conguraon (e. g. sta-
on address and baud rate) in order that the changed sengs become eecve.
For restarng communicaon, there are two opons:
1.
Switch inverter o and on again.
2.
0x2380 (P508.00) Set = 1 (Restart with current values).
12.16.1.1 Restarng or stopping the communicaon
Parameter
Address Name / seng range / [default seng] Info
0x2380
(P508.00)
PROFINET communicaon
(PROFINET comm.)
•
From version 02.00
Restart / stop communicaon
•
When the device command has been executed successfully, the value
0 is shown.
0 No acon/no error Only status feedback
1 Restart with current values Restart communicaon with the current values.
2 Restart with default values Restart communicaon with the values of the PROFINET parameters that
have been saved last (0x2381:001 ... 0x2381:009).
5 Stop network communicaon Stop communicaon
10 In process Only status feedback
11 Acon cancelled
12 Fault
12.16.1.2 Device descripon le
The device descripon le must be installed in the engineering tool for conguring the net-
work (e. g. Siemens »TIA Portal«).
•
Download of GSDML les
The name of the device descripon le is as follows:
"GSDML-V<x>.<zz>-Lenze-I<NNN>PN<Version>-<yyyy><mm><dd>.xml".
Wildcard Info
x Major version of the used GSDML scheme
zz One-digit or two-digit minor version of the used GSDML scheme
NNN Specifying the inverter name, e. g. i<550>, i<950>, ...
Version First soware version that can be used with this GSDML.
yyyy Year of publicaon
mm Month of publicaon
dd Day of publicaon
Conguring the network
PROFINET
Commissioning
483