Lenze i550

6.1.2 Keypad control
The "Keypad" control selecon enables the motor to be started exclusively via the start key of
the keypad. Other signal sources for starng the motor are ignored.
Details
If the keypad is to be used as the sole control source for the applicaon, selecon "Keypad
[1]" is to be set in 0x2824 (P200.00).
If the local keypad control is acve, "LOC" is displayed in the lower status row of the keypad.
The keys on the keypad then have the following funcon:
Funcon of keypad keys in operang mode
Key Actuaon Condion Acon
Shortly Local keypad control acve.
Display "LOC"
Run motor.
Shortly No Jog operaon Stop motor.
Display "KSTOP"
Shortly Operang mode Change to parameterisaon mode.
4Keypad parameterisaon mode ^ 554
Longer than 3 s None (anyme possible) Save parameter sengs in the user memory of the memory
module.
Shortly During operaon Scroll through informaon in the above status line.
CTRL
Shortly Operang mode Acvate full keypad control
Display "ON?" à Conrm with
Control and setpoint selecon can now only be carried out via
keypad.
Renewed clicking: Exit full keypad control.
Display "OFF?" à Conrm with
4Keypad full control ^ 58
R
F
Shortly Local keypad control acve.
Display "LOC"
Reversal of rotaon direcon.
Display "REV?" à Conrm with
4Congure R/F and CTRL keys ^ 581
•
The following funcons connue to be acve:
•
0x2631:001 (P400.01): Enable inverter
•
0x2631:003 (P400.03): Acvate quick stop
•
0x2631:005 (P400.05): Acvate DC braking
•
0x2631:010 (P400.10): Jog foward (CW)
•
0x2631:011 (P400.11): Jog reverse (CCW)
•
0x2631:013 (P400.13): Reverse rotaonal direcon
•
0x2631:043 (P400.43): Acvate fault 1
•
0x2631:044 (P400.44): Acvate fault 2
Related topics
4Keypad ^ 550
Start, stop and rotang direcon commands
Control selecon
Keypad control
57