Lenze i550

5.8.1 Select motor from motor catalogue
The following describes how to parameterise your drive system by selecng a Lenze motor
from the motor catalogue. Several processes are started invisibly in the background to load/
calculate the sengs for the relevant parameters.
Precondions
•
Access to a Lenze engineering tool (e. g. »EASY Starter«).
•
Parameters can be set online or oine (with or without connected motor).
Required steps
1.Open the Lenze engineering tool that provides for the funconality of a “Motor catalogue".
2.Click the Select motor... buon. In case of the »EASY Starter«, you nd the Select motor...
buon on the "sengs". tab.
3.Select the used motor in the "Select motor" dialog:
By entering lter criteria, you can restrict the selecon.
Name (e. g. "MCS..."), rated power and C86 value can be found on the motor
nameplate.
4.Press the Please select buon to select the thermal sensor.
This is not required for all motors. For older motors, such as MDSKA056-22 (C86=10), a ther-
mal sensor CANNOT be selected.
Observe the notes on the ? buon.
5.Click the OK buon to start the opmisaon.
Basic seng
Motor data
Select motor from motor catalogue
51