Lenze i550

16.1.2.5 Keypad parameter list
For commissioning or diagnoscs using the keypad, all parameters of the inverter that can
also be accessed by means of the keypad are listed in the following "Keypad parameter list".
•
The keypad parameter list is sorted in ascending order in compliance with the "display
code" (Pxxx).
•
In order to provide for quick access, all parameters of the inverter are divided into dier-
ent groups according to their funcon.4Parameter groups^ 554
•
Group 0 contains the congurable "Favorites". In the default seng these are the most
common parameters for the
soluon of typical applicaons. 4Favourites^ 32
A complete overview of all parameter indexes can be found in the annex in the
Parameter aribute list. ^ 660
Frequently used abbreviaons in the short keypad designaons of the parameters:
Abbreviaon Meaning
AI Analog input
AO Analog output
B0, B1, ... Bit 0, bit 1, ...
CU Control unit
DI Digital input
DO Digital output
LU Undervoltage
MOP Motor potenometer
NET Network
OU Overvoltage
PID Process controller
PU Power unit
QSP Quick stop
Setp Setpoint
WD Watchdog
How to read the keypad parameter list:
Column Meaning
Display code Parameter number on the keypad.
Format: Number.Subindex
Short designaon Short keypad designaon limited to 16 characters.
Default seng Default seng of the parameter.
Seng range Possible seng range for the parameter.
Format: minimum value ... maximum value [unit]
Address Address of the parameter in the object directory.
Format: Index:Subindex
Category Funconal assignment of the parameter, for example "motor control" or "CANopen".
Keypad parameter list (short overview of all parameters with display code)
Display code Short designaon Default seng Seng range Address Category
P100.00 Output frequency x.x Hz - (Read only) 0x2DDD general
P101.00 Scaled act value x Units - (Read only) 0x400D general
P102.00 Freq. setpoint x.x Hz - (Read only) 0x2B0E general
P103.00 Current actual x.x % - (Read only) 0x6078 general
P104.00 Motor current x.x A - (Read only) 0x2D88 general
P105.00 DC-bus voltage x V - (Read only) 0x2D87 general
P106.00 Motor voltage x VAC - (Read only) 0x2D89 general
P107.00 Torque actual x.x % - (Read only) 0x6077 general
P108.xx Output power
└ P108.01 Eecve power x.xxx kW - (Read only) 0x2DA2:001 general
* Default seng depending on the size.
Using accessories
Keypad
Keypad parameterisaon mode
558