Lenze i550

12.11 EtherNet/IP
EtherNet/IP™ (EtherNet Industrial Protocol) is a eldbus system based on Ethernet which uses
the Common Industrial Protocol™ (CIP™) for data exchange.
•
EtherNet/IP™ and Common Industrial Protocol™ (CIP™) are trademarks and patented tech-
nologies, licensed by the user organisaon ODVA (Open DeviceNet Vendor Assoziaon),
USA.
•
Detailed informaon on EtherNet/IP can be found on the web page of the user organisa-
on: hp://www.odva.org
•
Informaon about the dimensioning of a EtherNet/IP network can be found in the congu-
raon document for the inverter.
The inverter can be controlled by any CIP Generic Master which either supports "Class 1 Mes-
saging" or "Class 3 Messaging". In this case, the inverter must be congured as an AC drive
Adapter with the programming soware »RSLogix™ 5000« by Rockwell Automaon® Corpora-
on. 4Commissioning ^ 396
Registered trademarks used or trademarks of the Rockwell Automaon® Corporaon, USA:
•
»RSLogix™«, »RSLogix™ 5000«
•
»Allen-Bradley®«
•
»CompactLogix™«, »ControlLogix®«, »SoLogix™«
Precondions
•
The control unit (CU) of the inverter is provided with EtherNet/IP (from rmware 02.01).
Typical topologies
Line Tree
S
R
An
A2A1
S
SWn
SW2
SW1
Ring
S
An
A2
A1
A3
DLR
S Scanner SW Switch
A Adapter
Conguring the network
EtherNet/IP
395