Lenze i550

16.1.3 Keypad sengs
For the keypad various sengs can be made, which are described in detail in the following
subchapters.
16.1.3.1 Select language
Parameter
Address Name / seng range / [default seng] Info
0x2863
(P705.00)
Keypad language selecon
(KP language)
Language selecon for the keypad display.
0 No language selected
1 English
2 German
16.1.3.2 Change setpoint increment
Parameter
Address Name / seng range / [default seng] Info
0x2862
(P701.00)
Keypad setpoint increment
(KP setp. incr.)
1 ... [1] ... 100
Adaptaon of the increment for keypad setpoints when a keypad arrow
key is pressed once. The value set serves as a mulplier for the preset
increments.
Seng 1 corresponds to the following increments:
•
0.1 Hz for frequency setpoint 0x2601:001 (P202.01).
•
0.01 PUnit for process controller setpoint 0x2601:002 (P202.02).
•
0.1 % for torque setpoint 0x2601:003 (P202.03).
Notes:
•
With a seng > 1, the opon of repeatedly changing the setpoint by
pressing the key for a longer me is deacvated.
•
The seng only has an impact on the keypad setpoints.
Example: with the seng "5", the keypad frequency setpoint is
increased/decreased by 0.5 Hz every me the key is pressed.
16.1.3.3 Congure status display
During operaon, the keypad displays the output frequency of the inverter, or with an acve
PID control it shows the process controller setpoint. Alternavely, an oponal diagnosc
parameter can be displayed during operaon.
Parameter
Address Name / seng range / [default seng] Info
0x2864
(P703.00)
Keypad status display
(KP status displ.)
0x00000000 ... [0x00000000] ... 0xFFFFFF00
0 = normal display depending on the operang mode
•
In case of an acve frequency control, the keypad displays the output
frequency of the inverter.
•
In case of acve PID control, the keypad displays the current Process
controller setpoint in [P-Unit].
As an alternave, an oponal diagnosc parameter can be set here,
which is to be shown on the keypad during operaon.
•
Format: 0xiiiiss00 (iiii = hexadecimal index, ss = hexadecimal subindex)
•
The lowest byte is always 0x00.
•
The keypad can be used to select the desired diagnoscs parameter
from a list.
0x4002
(P702.00)
Speed display scaling
(Scal.speed fact.)
0.00 ... [0.00] ... 650.00
Factor for the scaling of the speed display in 0x400D (P101.00).
•
With the seng "0.00", no scaling takes place.
•
Example: with the "16.50" and the actual frequency = 50 Hz, 0x400D
(P101.00) shows the speed "825 units".
Using accessories
Keypad
Keypad sengs
580