Lenze i550

Parameter
Address Name / seng range / [default seng] Info
0x2300
(P508.00)
CANopen communicaon
(CANopen comm.)
•
Seng can only be changed if the inverter is inhibi-
ted.
Restart / stop communicaon.
•
Aer successful execuon, the value 0 is shown.
0 No acon/no error Only status feedback
1 Restart with current values Restart communicaon with the current values.
2 Restart with default values Restart communicaon with the standard values of the CAN parameters
(0x1000 ... 0x1FFF and 0x2301).
5 Stop network communicaon Stop communicaon.
•
The "Stop Remote Node" NMT command is executed. Aer successful
execuon of this command, only the recepon of network manage-
ment frames is possible.
10 In progress Only status feedback
11 Acon cancelled
12 Fault
Conguring the network
CANopen
Commissioning
347