Lenze i550

t
t
0 Hz
30 Hz
10 Hz
20 Hz
40 Hz
50 Hz
60 Hz
0 Hz
30 Hz
10 Hz
20 Hz
40 Hz
50 Hz
60 Hz
-40 Hz
-60 Hz
-50 Hz
-30 Hz
-20 Hz
-10 Hz
t
t
t
t
t
t
t
0x2DDD
Start enable
Digital input 2 [12] Run forward (CW)
Digital input 1 [11] Run
Digital input 3 [13]
Constant TRUE [1]
Stop active [53]
Rotational direction reversed [69]
Running [50]
Output signals
Status signals
Output frequency
Run reverse (CCW)
Enable inverter
Input signals
Frequency setpoint selection
FunctionTrigger
The status signals can be assigned to digital outputs. 4Congure digital outputs ^ 263
①
The "Run" funcon serves as start enable for the funcons "Run forward (CW)" and "Run reverse (CCW)".
Without start enable, the motor cannot be started.
②
If the start command is cancelled, the motor is stopped with the stop method set in 0x2838:003 (P203.03). In the example: Stop with stand-
ard ramp.
Aer a renewed start enable, the inverter waits for the next run command.
③
If, at start enable, either "Run forward (CW)" or "Run reverse (CCW)" is set to TRUE, the motor starts in the triggered direcon.
④
The inverter always responds to the run command detected last (if start enable is available).
In the example, the "Run reverse (CCW)" command replaces the sll acve "Run forward (CW)" command.
⑤
If, at start enable, both run commands are set to TRUE, the motor remains stopped unl only one valid run command is available.
Start, stop and rotang direcon commands
Flexible I/O conguraon of the start, stop and rotang direcon commands
Example: Run forward/Run reverse/stop (status-controlled)
71