Lenze i550

t
t
t
0 Hz
30 Hz
10 Hz
20 Hz
40 Hz
50 Hz
60 Hz
0 Hz
30 Hz
10 Hz
20 Hz
40 Hz
50 Hz
60 Hz
-40 Hz
-60 Hz
-50 Hz
-30 Hz
-20 Hz
-10 Hz
t
t
t
t
t
t
t
t
0x2DDD
Stop
RunKeypad keys
Constant TRUE [1] Enable inverter
Digital input 2 [12]
Digital input 1 [11]
Local control active [104]
Remote control active [105]
Running [50]
Stop active [53]
Output signals
Status signals
Output frequency
Activate keypad control
Run
Input signals
Frequency setpoint selection
FunctionTrigger
The status signals can be assigned to digital outputs. 4Congure digital outputs ^ 263
①
When changing over to another control source, the motor is rst stopped with the stop method set in 0x2838:003 (P203.03).
②
The motor will also be stopped if the "Run" funcon is deacvated or the keypad key is pressed (irrespecve of the acve control
source).
③
Aer stopping with the keypad key and before a renewed start command from another control source, the key on the keypad must
be pressed to cancel the keypad stop again ("KSTOP").
Start, stop and rotang direcon commands
Changing the control source during operaon
Example: Change-over from terminal control to keypad control
80