NEC Univerge SV9100 - Page 1075

1075
Guide to Feature Programming
 The items highlighted in gray are read only and cannot be changed.
Program
Number
Program Name/Description
Input Data
Default
10-03-03
ETU Setup – Number of Voice Channels
Read only program showing number of VoIP
resources available for voice calls.
This information can also be viewed by
pressing Feature+4 on an idle display terminal.
10-54-01
License Configuration for Each Package –
License Code
Assign VoIP Resource Licenses (5103) to
GCD-CP10 slot (1).
If applying more than 255 licenses to a slot, the
licenses must be applied across multiple
indexes.
For example, assigning 256 VoIP resource
licenses (5103) to the CPU slot could be
assigned using different methods as long as the
total for the CPU slot is 256.
1. Index 1 has 128 of feature code 5103 and
index 2 also has 128 of feature code 5103 for a
total of 256.
2. Index 1 has 255 of feature code 5103 and
index 2 has 1 of feature code 5103 for a total of
256.
1 ~ 255 Resource Licenses
0
11-19-01
Remote Conference Group Pilot Number
Enter the pilot number for remote conference.
Must work within current system
dialing plan.
No Setting
14-18-03
IP Trunk Data Setup – P2P Mode (SIP Trunk)
Select whether or not peer-to-peer connection
method is used for the SIP Trunk.
0 = Disable
1 = Enable
0
14-18-04
IP Trunk Data Setup – Video Mode (SIP
Trunk)
Select whether or not the video mode is used
for the SIP Trunk.
This program is not supported for v 1.00 and
will be added in a future release.
0 = Disable
1 = Enable
0
15-05-43
IP Telephone Terminal Basic Data Setup –
Video Mode
Enable/Disable Video Mode for Standard SIP
terminals.
0 = Disable
1 = Enable
0