NEC Univerge SV9100 - Page 1078

1078
Program
Number
Program Name/Description
Input Data
Default
84-13-75
SIP Trunk CODEC Information Basic Setup –
Maximum Jitter Buffer for Video
Sets the maximum value of jitter buffer for the
video stream. It is used only when Program
84-19-72 (Jitter Buffer Mode for video) is set to
1: Fixed.
This value must be larger than the value of the
minimum jitter buffer.
This value should only be changed if needed
for highly congested networks.
This program is not supported for v 1.00 and
will be added in a future release.
0 ~ 1000ms
210ms
84-19-65
SIP Extension CODEC Information Basic
Setup – Video Quality Mode
Specifies the SIP station video quality mode
when Peer to Peer is disabled in Program
15-05-50.
Mode 1 = CIF (352x288)
Mode 2 = VGA (640x480)
Used with Programs 84-27-20 for Mode 1 and
84-27-21 for Mode 2 video quality settings.
0 = Mode 1
1 = Mode 2
0
84-19-66
SIP Extension CODEC Information Basic
Setup – Video CODEC
This program specifies the video CODEC
(H.264 only).
0 = H.264
0
84-19-67
SIP Extension CODEC Information Basic
Setup – Jitter Buffer Mode for Video
Sets the jitter buffer size adjustment. At default
this is set to self adjusting and should only be
changed when directed by support.
1 = Static
2 = Self adjusting
2
84-19-68
SIP Extension CODEC Information Basic
Setup – Minimum Jitter Buffer for Video
Sets the minimum value of jitter buffer for the
video stream.
This value must be smaller than the value of the
maximum jitter buffer.
This value should only be changed if needed
for highly congested networks.
0 ~ 1000ms
70ms
84-19-69
SIP Extension CODEC Information Basic
Setup – Initial Jitter Buffer for Video
Sets the initial value of jitter buffer for the video
stream.
This value must be smaller than the value of the
maximum jitter buffer and larger than the value
of the minimum jitter buffer.
This value should only be changed if needed
for highly congested networks.
0 ~ 1000ms
140ms