1077
ToS Setup – High Reliability
1 = Optimize for reliability routing.
0 ~ 1
0 = Normal Reliability
1 = Low Reliability
ToS Setup – Priority (D.S.C.P. -
Differentiated Services Code Point)
DSCP (Differentiated Services Code Point).
SIP Trunk CODEC Information Basic Setup –
Video Quality Mode
Specifies the SIP trunk video quality mode.
Mode 1 = CIF (352x288)
Mode 2 = VGA (640x480)
Used with Programs 84-27-20 for Mode 1 and
84-27-21 for Mode 2 video quality settings.
This program is not supported for v 1.00 and
will be added in a future release.
SIP Trunk CODEC Information Basic Setup –
Video CODEC
This program specifies the video CODEC
(H.264 only).
This program is not supported for v 1.00 and
will be added in a future release.
SIP Trunk CODEC Information Basic Setup –
Jitter Buffer Mode for Video
Sets the jitter buffer size adjustment. At default
this is set to self adjusting and should only be
changed when directed by support.
This program is not supported for v 1.00 and
will be added in a future release.
1 = Static
2 = Self adjusting
SIP Trunk CODEC Information Basic Setup –
Minimum Jitter Buffer for Video
Sets the minimum value of jitter buffer for the
video stream.
This value must be smaller than the value of the
maximum jitter buffer.
This value should only be changed if needed
for highly congested networks.
This program is not supported for v 1.00 and
will be added in a future release.
SIP Trunk CODEC Information Basic Setup –
Initial Jitter Buffer for Video
Sets the initial value of jitter buffer for the video
stream.
This value must be smaller than the value of the
maximum jitter buffer and larger than the value
of the minimum jitter buffer.
This value should only be changed if needed
for highly congested networks.
This program is not supported for v 1.00 and
will be added in a future release.
To Next Page
Loading...
