1097
Single Line Telephone Basic Data Setup –
Answer On-Hook when Holding (SLT)
Enable/Disable Answer ON-Hook when Holding
for SLT terminals.
0 = Disable (No)
1 = Enable (Yes)
Single Line Telephone Basic Data Setup –
Caller ID Function - For External Module
Enable/Disable the Caller ID FSK signal for an
external Caller ID module or a 3rd-Party vendor
telephone with Caller ID display.
Important:
If voice mail is used, this setting must be
disabled for the system integration codes to be
correct.
With a 2500 set (no Caller ID) installed, this
must be set to 0 for incoming callers to have a
talk path.
Single Line Telephone Basic Data Setup –
Caller ID Name
Determine if an extension user telephone
should display the Caller ID name.
Single Line Telephone Basic Data Setup –
Forwarded Caller ID Display Mode
Determine what the display shows when a
multiline terminal receives a forwarded outside
call.
0 = Calling Extension Number
(Calling)
1 = External Caller ID (Forward)
System Options for Single Line Telephones
– SLT Call Waiting Answer Mode
For a busy single line (500/2500 type)
telephone, set the mode used to answer a
camped-on trunk call.
For ESL sets, enable this option (1) to allow the
user to dial Service Code for Voice Mail
Conversation Record.
0 = Hookflash (Hooking)
1 = Hookflash + Service Code
794
Service Code 654 is for Live
Recording at SLT (Program
11-12-53).
System Options for Single Line Telephones
– Ignore Received DP Dial on DTMF SLT
Port
Define whether the system should receive dial
pulse and DTMF signals (0) or ignore dial pulse
and only accept DTMF signals (1).
0 = Do not ignore (No)
1 = Ignore (Yes)
System Options for Single Line Telephones
– SLT DTMF Dial to Trunk Lines
Set the SLT phones to (0). Collect all digits
before sending or (1), send out immediately
after receiving. When using a third-party
external paging device, set this option to 1. In
addition, set Program 20-03-04 to 1.
0 = Receive all dialed data,
before sending (All)
1 = Direct through out (Direct)
To Next Page
Loading...
