1107
Conditions
Speed Dial bins can contain stored Account Codes. To prevent them from being displayed
use Program 35-05-04.
ARS selects the trunk for the call unless the user preselects.
A user can implement Speed Dial only if their extension has outgoing access to trunks.
An extension can have a One-Touch Key for Speed Dial operation.
If you enter a PBX trunk access code in a Speed Dial bin, the system automatically inserts
a pause after the bin.
Single line telephones can dial only System and Group Speed Dial numbers.
Toll Restriction may prevent a user from using a stored Speed Dial number.
Unless a user preselects a trunk, Trunk Group Routing selects the trunk Speed Dial uses
for trunk calls.
If the Speed Dial bin does not have a name assigned, it does not show when scrolling
through the directory of speed dials.
If Program 13-01-01 is set to 1 (Intercom Access mode), system speed dial bins require
inserting a trunk access code.
When operating the Right Cursor key, if the menu is not enabled by programming or there
are no numbers in a telephone book, the menu is skipped and the next menu will appear.
For DT3XX or DT7XX terminals, use the Feature Key to clear the characters one at a time
when entering the name.
The priority for the Large LED color for incoming calls is Programs 13-04-13, then 14-01-35
or 15-23-01.
Default Settings
Available (No Speed Dialing bins are assigned).
System Availability
Terminals
All Terminals
Required Component(s)
None
To Next Page
Loading...
