NEC Univerge SV9100 - Page 1150

1150
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-11-22
Service Code Setup (for Setup/Entry
Operation) – Extension Name Programming
Customize the extension name programming
used for registration and setup.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
800
15-01-01
Basic Extension Data Setup – Extension
Name
Define the extension/virtual extension name.
Maximum of 12 characters.
STA 101 = Ext
101
STA 102 = Ext
102, etc.
15-07-01
Programmable Function Keys
Assign an Extension Name Change key (55) to
extensions.
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
20-06-01
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-13-21
Class of Service Options (Supplementary
Service) – Extension Name
Turn Off or On an extension user ability to
program its name.
0 = Off
1 = On
COS 1 ~ 15 = 1
Operation
To program your extension name:
1. Press Speaker.
2. Dial 800.
- OR -
Press the Extension Name Change key (Program 15-07 or SC 851: 55).
3. Press Hold.
4. Enter the name. (Refer to Table 2-99 Keys for Entering Names.)
 Your name can be up to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
To program any extension name:
1. Press Speaker.
2. Dial 800.
- OR -