NEC Univerge SV9100 - Page 1151

1151
Press the Extension Name Change key (Program 15-07 or SC 851: 55).
3. Enter the extension number to be named.
4. Enter a name. (Refer to Table 2-99 Keys for Entering Names.).
 The name can be have to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter ch3aracters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
Keys for Entering Names (Continued)
Use this keypad digit . . . When you want to. . .
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü   
*
Enter characters:
* + , - . / : ; < = > ? π Σ Ω ∞ ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed - ex: TOM).
Pressing # again = Space. (In system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)
Feature
Clear the character entry one character at a time (when using service code or
function key).
Recall
Clear the character entry one character at a time (when in telpro).
Hold (Telpro Mode Only)
Clear all the entries from the point of the flashing cursor and to the right.