NEC Univerge SV9100 - Page 1169

1169
Program
Number
Program Name/Description
Input Data
Default
51-14-01
NetLink System Control – Delete System
Information
Delete system information and the slot
information. The system must be disconnected.
This program is available only via telephone
programming and not through PC Programming.
1 ~ 50
1
51-15-01
Demonstration Setting
Automatically set the minimum setting values in
NetLink. A system reset occurs after this
command is executed.
(This program is available only via telephone
programming and not through PC Programming).
1 = Primary automatic setting
2 = Secondary 1 - automatic
operation setting
3 = Secondary 2 - automatic
operation setting
4 = Secondary 3 - automatic
operation setting
No Setting
51-16-01
NetLink System Data Replication Mode
Setting – System Data Replication Mode
Set the synchronous mode of the system data.
When set to 1, the systems are synchronized at
the time set in Item 02 below.
When set to 2, the systems are synchronized at
regular time intervals set in Item 03 below.
0 = Disable
1 = Setting Time Mode
2 = Interval Mode
2
51-16-02
NetLink System Data Replication Mode
Setting – System Data Replication Time
Setting
Set the time of day that both systems
synchronize database (when Item 01 is set to
1).
0000 ~ 2359
0000
51-16-03
NetLink System Data Replication Mode
Setting – System Data Replication Interval
Setting
Set the time that both systems synchronize
database (when Item 01 is set to 2).
15 ~ 1440 minutes
30
51-16-04
Replication Time Stamp
Show next replication time.
(Read Only)
Month: 0~12
No Setting
Day: 0~31
Hour: 00~23
Minute: 00~59.
51-16-05
NetLink System Data Replication Mode
Setting – System Data Replication Wait Time
Set the wait time until replication starts when
NetLink is created.
1 ~ 86400 seconds
180
51-16-06
NetLink System Data Replication Mode
Setting – System Data Replication Interval
Set an interval time to start replication to the
next node after replication to one node is
completed.
1 ~ 86400 seconds
1