NEC Univerge SV9100 - Page 1170

1170
Program
Number
Program Name/Description
Input Data
Default
51-17-01
NetLink DT800/DT700 Server Individual
Information Setup – Registrar Port
Use to set the SIP Register Port of each
system.
0 ~ 65535
5080
51-17-02
NetLink DT800/DT700 Server Individual
Information Setup – Subscribe Session Port
Use to set the SIP Subscribe Session Port
number of each system when NetLink is used.
0 ~ 65535
5081
51-18-01
Netlink Configuration Options – Netlink Fail-
Over Limit
When tear-down of network was repeated more
than the specified times, NetLink is operated
stand-alone.
0, 2 ~ 10
(0 = Infinity)
0
51-19-01
NetLink IP Trunk (SIP) Calling Party Number
Setup for Extension – NetLink CPN
Transmission
This program assigns transmission of Calling
Party Number (CPN) from Program 21-19 for
each secondary system. The transmission
applies for every extension.
0 = Disable
1 = Enable
1
84-26-01
IPL Basic Setup – IP Address
Assign the IP address for each DSP on the
GPZ-IPLE.
xxx.xxx.xxx.xxx
Slot 1 =
172.16.0.20
84-26-02
IPL Basic Setup – RTP Port Number
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
0 ~ 65534
VoIP GW1 =
10020
84-26-03
IPL Basic Setup – RTCP Port Number (RTP
Port Number +1)
Assign the RTCP Port number to used for each
DSP on the GPZ-IPLE.
0 ~ 65534
VoIP GW1 =
10021
Operation
None