NEC Univerge SV9100 - Page 1252

1252
Hold
Message Waiting
One-Touch Calling
Programmable Function Keys
Transfer
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-09-01
DTMF and Dial Tone Circuit Setup
Assign at least one circuit for DTMF reception
(type 0 or 1). Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one DTMF
receiver for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF
receiver for every five devices that use
them.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
10-55-01
Package Network Setup – IP Address
Define the IP Address for the GCD-ETIA.
When the blade is deleted from the system
using Program 90-05, the programming for the slot
in 10-55 is set back to default.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255255.254
192.0.0.1 ~ 223.255.255.254
172.16.1.100
10-55-03
Package Network Setup – Main/Add-on
Set to 0 to distribute an IP Address to the blade.
0 = Main
1 = Add-on
1
10-55-04
Package Network Setup – Sub Net Mask
Define the subnet mask for the GCD-ETIA.
128.0.0.0 | 192.0.0.0 | 224.0.0.0
|240.0.0.0 | 248.0.0.0 | 252.0.0.0
|254.0.0.0 | 255.0.0.0
|255.128.0.0 | 255.192.0.0
|255.224.0.0 | 255.240.0.0
|255.248.0.0 | 255.252.0.0
|255.254.0.0 | 255.255.0.0
|255.255.128.0 | 255.255.192.0
|255.255.224.0 | 255.255.240.0
|255.255.248.0 | 255.255.252.0
|255.255.254.0 | 255.255.255.0
|255.255.255.128
|255.255.255.192
|255.255.255.224
|255.255.255.240
|255.255.255.248
|255.255.255.252
|255.255.255.254
|255.255.255.255
255.255.0.0
10-55-05
Package Network Setup – Default Gateway
Define the default gateway for the GCD-ETIA.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0