1276
Class of Service Options (Hold/Transfer
Service) – Department Group Trunk-to-
Trunk Transfer (Each Telephone Group
Transfer)
Turn Off or On an extension user ability in a
Department Group to use the Trunk-to-Trunk
Forwarding service codes.
Class of Service Options (Supplementary
Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension to Manually (0) or
Automatically (1) receive off-hook Signals.
This setting is to receive incoming call
signaling information during call queuing.
Class of Service Options (Supplementary
Service) – Department Calling (PLT No
Called Extension)
Turn Off or On an extension user ability to call a
Department Group Pilot.
Incoming Call Trunk Setup
If you want a trunk to be a DIL to a Department
Group, assign Service Type 4 for each Night
Service Mode. Also see Program 22-07-01.
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
DIL Assignment
For each trunk assigned Service Type 4 in
Program 22-02 above, assign the DIL
destination as the Department Group pilot
number (as assigned in Program 11-07-01).
(Department: Groups 1 ~ 64).
For this selection to work, set Program
22-02-01 to 4 (DIL).
Day/Night Modes (1 ~ 8):
Extension Number (maximum of
eight digits)
Pilot Number
System Options for Transfer – Message Wait
Ring Interval Time
For Single Line Telephones (SLTs) without
message waiting lamps, this is the time
between intermittent ringing. If this value is 0,
the system rings once.
System Options for Transfer – Delayed
Transfer Timer for All Department Groups
Determine the time a call should ring a
Department Group before transferring the call.
Department Group Transfer Target Setup
Use the Speed Dialing area to program the
destination number of the transferred telephone
number when a Department Group call is
transferred using Trunk-to-Trunk Forwarding.
To Next Page
Loading...
