NEC Univerge SV9100 - Page 1281

1281
Program
Number
Program Name/Description
Input Data
Default
44-02-01
Dial Analysis Table for ARS/F-Route Access
– Dial
Set the dial digits to be analyzed by the system
for ARS routing.
Maximum of eight digits
(Use line key 1 for a ‘Don’t Care’
digit, @)
No Setting
44-02-02
Dial Analysis Table for ARS/F-Route Access
– Service Type
Select the Service Type.
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
0
44-02-03
Dial Analysis Table for ARS/F-Route Access
– Additional Data
Enter the additional data required for the
service type selected in Program 44-02-02,
either the number of digits to be deleted or the
table number to be used.
1 = Delete Digit = 0 ~ 255
(255: Delete All Digits)
2 = 0 ~ 500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0 ~ 4
(0 = No Setting)
0
44-02-04
Dial Analysis Table for ARS/F-Route Access
– Dial Tone Simulation
If Enabled (1), this option sends dial tone to the
calling party after the routing is determined.
This may be required if the central office at the
destination does not send dial tone.
0 = Off
1 = On
0
44-03-01
Dial Analysis Extension Table – Dial
Set the Dial digits (24 digits maximum) 1 ~ 9, 0
* #, @) to be used for the Dial Extension
Analysis Table. When Program 44-02-02 is set
to 3, this program sets the dial extension
analysis table. These tables are used when the
analyzed digits must be more than eight digits.
To enter a wild card/don’t care digit, press Line
Key 1 to enter an @ symbol.
Maximum of 24 digits
Digits = 1 ~ 9, 0, *, #, @
(Press Line Key 1 for wild
character @)
No Setting
44-03-02
Dial Analysis Extension Table – ARS/
F-Route Select Table Number
When dialed digits match the setting in
Program 44-03-01, select the ARS/R-Route
table number (0 ~ 500) to be used for the Dial
Extension Analysis Table.
0 ~ 500
(ARS/F-Route Table Number)
With Program 44-01 set to 0,
Program 44-05 is checked.
With Program 44-01 set to 1,
Program 44-04 is checked.
0
44-03-03
Dial Analysis Extension Table – ARS/
F-Route Select Table Number
If the received digits are not identified in tables
1 ~ 250, the F-Route selection table number (0
~ 500) defined in table 251 is used.
0 ~ 500
(ARS/F-Route Table Number)
With Program 44-01 set to 0,
Program 44-05 is checked.
With Program 44-01 set to 1,
Program 44-04 is checked.
0