NEC Univerge SV9100 - Page 1282

1282
Program
Number
Program Name/Description
Input Data
Default
44-03-04
Dial Analysis Extension Table – Next Table
Area Number (252)
If the received digits do not match the digits set
in tables 1 ~ 250, table number 252 is used
refer to the next Extension Table Area (1 ~ 4) to
be searched.
0 ~ 4
0
44-04-01
ARS/F-Route Selection for Time Schedule
Assign each ARS/F-Route Selection number
(1 ~ 500) to an ARS/F-Route table number for
each ARS/F-Route time mode.
ARS/F-Route Time Mode: 1 ~ 8
ARS/F-Route Table Number = 0
~ 500
0
44-05-01
ARS/F-Route Table – Trunk Group Number
Select the trunk group number used for the
outgoing ARS call (1 ~ 100).
0 ~ 100, 255
0 = No Setting
255 = Extension Call
0
44-05-02
ARS/F-Route Table – Delete Digits
Enter the number of digits to be deleted from
the dialed number [0 ~ 255 (255 = Delete all)].
0 ~ 255
(255 = Delete All)
0
44-05-03
ARS/F-Route Table – Additional Dial Number
Table
Enter the table number defined in Program
44-06 for additional digits to be dialed
(0 ~ 1000).
0 ~ 1000
0
44-05-04
ARS/F-Route Table – Beep Tone
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Turn Off or On a beep
tone if a lower priority trunk group is used.
0 = Off (No Beep)
1 = On (Beep)s
0
44-05-05
ARS/F-Route Table – Gain Table Number for
Internal Calls
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the gain table
number used for internal call (defined in
Program 44-07).
0 ~ 500
0 = No Setting
0
44-05-06
ARS/F-Route Table – Gain Table Number for
Tandem Connections
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the gain table
number used for the tandem call (defined in
Program 44-07).
0 ~ 500
0 = No Setting
0
44-05-07
ARS/F-Route Table – ARS Class of Service
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the Class of
Service used for ARS. An extension ARS COS
is determined in Program 26-04-01.
0 ~ 16
0
44-05-08
ARS/F-Route Table – Dial Treatment
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the Dial
Treatment to be used for the table. The Dial
Treatments are determined in Program
26-03-01.
0 ~ 15
0