NEC Univerge SV9100 - Page 198

198
Program
Number
Program Name/Description
Input Data
Default
11-11-13
Service Code Setup (for Setup/Entry
Operation) – Display Language Selection for
Multiline Terminal
Select the service code which can be used at
an extension to change the displayed language
on a multiline terminal display.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
778
11-12-01
Service Code Setup (for Service Access) –
Bypass Call
Define the service code for Activating Call
Forwarding/Do Not Disturb Override. This code
is available only if you disable the voice mail
Single Digit dialing code in Program 11-16-09.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
807
11-12-14
Service Code Setup (for Service Access) –
Trunk Group Access
Define the service code which should be used
by an extension user to select outgoing Trunk
Group.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
804
14-01-01
Basic Trunk Data Setup – Trunk Name
Set the names for trunks. The trunk name
displays on a multiline terminal for incoming
and outgoing calls.
Maximum of 12 Characters
Line 001
Line 002
Line 003
:
Line 400
14-01-02
Basic Trunk Data Setup – Transmit Level
Customize the transmit and receive levels of
the CODEC Gain Types for each trunk.
Trunks 1 ~ 400
1 ~ 57
(-15.5 ~ +12.5dB in 0.5dB
intervals)
32 (0dB)
14-01-03
Basic Trunk Data Setup – Receive Level
Customize the transmit and receive levels of
the CODEC Gain Types for each trunk.
Trunks 1 ~ 400
1 ~ 57
(-15.5 ~ +12.5dB in 0.5dB
intervals)
32 (0dB)
14-01-07
Basic Trunk Data Setup – Outgoing Calls
Allow or Deny outgoing calls on the trunk you
are programming.
0 = Deny (No)
1 = Allow (Yes)
1
14-01-10
Basic Trunk Data Setup – DTMF Tones for
Outgoing Calls
For each trunk, Enable/Disable the ability to
hear the DTMF of the digits dialed when placing
the outgoing call.
0 = Disable
1 = Enable
0
14-02-05
Analog Trunk Data Setup – Dial Tone
Detection for Manually Accessed Trunks
Enable/Disable dial tone detection for directly
accessed trunks. If disabled, the system
outdials on the trunks without monitoring for dial
tone.
0 = Dial Tone Detection Not
Used
1 = Dial Tone Detection Used
0
14-02-11
Analog Trunk Data Setup – Next Trunk in
Rotary if No Dial Tone
Enable/Disable the system ability to skip over a
trunk if dial tone is not detected. This option
pertains to calls placed using Call Appearance
(CAP) Keys, Speed Dial, Automatic Route
Selection (ARS) (ARS), Last Number Redial or
Save Number dialed. It does not pertain to line
key or Direct Trunk Access calls.
0 = Disable
1 = Enable
0