NEC Univerge SV9100 - Page 346

346
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
10-09-01
DTMF and Dial Tone Circuit Setup
If dial tone detection is enabled, be sure to
allocate at least one circuit for dial tone
detection [ICM/Trunk (0) or Trunk (2)].
0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
14-02-05
Analog Trunk Data Setup – Dial Tone
Detection for Manually Accessed Trunks
Enable/Disable dial tone detection for directly
accessed trunks. If disabled, the system
outdials on the trunks without monitoring for dial
tone.
0 = Dial Tone Detection Not
Used
1 = Dial Tone Detection Used
0
14-02-11
Analog Trunk Data Setup – Next Trunk in
Rotary if No Dial Tone
If Enabled, the system skips over a trunk if dial
tone is not detected. This option pertains to
calls placed using Call Appearance (CAP)
Keys, Speed Dial, ARS, Last Number Redial or
Save Number Dialed. It does not pertain to line
key or Direct Trunk Access calls.
0 = Disable
1 = Enable
0