NEC Univerge SV9100 - Page 347

347
Program
Number
Program Name/Description
Input Data
Default
21-01-04
System Options for Outgoing Calls – Dial
Tone Detection Time
If dial tone detection is Enabled, the system
waits this time for the Telco to return dial tone.
When the time expires, the system assumes
dial tone is not present. To disable this time
(and have the system wait continuously), enter
0.
0 ~ 64800 seconds
5
21-01-05
System Options for Outgoing Calls –
Disconnect Time When Dial Tone Not
Detected
If 14-02-11 is Enabled, the system skips over a
trunk if dial tone is not detected. This option
pertains to calls placed using Speed Dial, ARS,
Last Number Redial or Save Number dialed. It
does not pertain to line key or Direct Trunk
Access calls.
0 ~ 64800 seconds
3
21-01-06
System Options for Outgoing Calls – Dial
Pause at First Digit
If Dial Tone Detection is Disabled, the system
waits this time before sending dialed digits. If
using Dial Tone Detection, this time should be
set longer than the time set in Program
21-01-05, otherwise, if this time is set shorter
than Program 21-01-05, Dial Tone Detection is
satisfied and Program 21-01-05 is disregarded
(not used).
0 ~ 64800 seconds
1
Dial Tone Detection Program Interaction
Method
14-02-05
14-02-11
Result if dial tone
not present . . .
Press a line key
- or -
Dial #9+ Trunk
number
0
0
Trunk hangs (does not disconnect)
0
1
Trunk hangs (does not disconnect)
1
0
Trunk drops
1
1
Trunk drops
Dial a Trunk Group
code
- or -
Automatically
through a feature
0
0
Trunk hangs (does not disconnect)
0
1
Trunk reroutes after time-out
1
0
Trunk drops
1
1
Trunk reroutes after time-out
Operation
Dial Tone Detection is automatic if enabled in programming.