NEC Univerge SV9100 - Page 411

411
Program
Number
Program Name/Description
Input Data
Default
22-03-01
Trunk Ring Tone Range
Set the ring tone range (1 ~ 9) for each trunk.
0 = Ring Tone Pattern 1
1 = Ring Tone Pattern 2
2 = Ring Tone Pattern 3
3 = Ring Tone Pattern 4
4 = Melody 1
5 = Melody 2
6 = Melody 3
7 = Melody 4
8 = Melody 5
9 = Ring Tone Pattern 5
10 = Ring Tone Pattern 6
11 = Ring Tone Pattern 7
12 = Ring Tone Pattern 8
0
80-01-01
Service Tone Setup – Repeat Count
Customize the system basic tones and system
service tones. You need to reset for the
changes to take effect.
0 ~ 255 (0 = until On-Hook)
0~255 (0 = until
On-Hook)
80-01-02
Service Tone Setup – Basic Tone Number
The following features require that the system
tones listed below be changed to match the
table. After changing these settings the chassis
must be reset for the changes to take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
1 ~ 33
(0 = No Tone)
(33 = Default Time Slot)
33 = Default
Time Slot
Refer to Table 2-
17 Basic Tone
Table – Tone 06
80-01-02
Service Tone Setup – Basic Tone Number
Refer to Table 2-
(14)
The following features require that the system
18 Basic Tone
tones listed below be changed to match the
Table – Tone 14
table. After changing these settings the chassis
must be reset for the changes to take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
80-01-02
Service Tone Setup – Basic Tone Number
Refer to Table 2-
(39)
The following features require that the system
19 Basic Tone
tones listed below be changed to match the
Table – Tone 39
table. After changing these settings the chassis
must be reset for the changes to take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer