NEC Univerge SV9100 - Page 545

545
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-12-30
Service Code Setup (for Service Access) –
Specified Trunk Answer
If required, redefine the service code used to
answer a specific trunk which is either ringing or
on hold.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
772
11-12-33
Service Code Setup (for Service Access) –
Group Hold
If required, redefine the service code used to
answer a specific trunk which is either ringing or
on hold.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
832
11-12-34
Service Code Setup (for Service Access) –
Answer for Group Hold
If required, redefine the service code used to
answer a specific trunk which is either ringing or
on hold.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
862
14-01-16
Basic Trunk Data Setup – Forced Release of
Held Call
Enable/Disable Forced Release of Held Call.
0 = Disable
1 = Enable
0
14-07-01
Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the
access options for trunks.
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on
Hold
4 = Outgoing access and access
when trunk on Hold
5 = Incoming access and access
when trunk on Hold
6 = Incoming and Outgoing
access
7 = Incoming access, outgoing
access and access when trunk
on Hold
Trunk Access Maps: 1 ~ 400
Access Maps
1 ~ 400 = Trunk
Ports 1 ~ 400
assigned with
option 7 access
(incoming and
outgoing access
and access
when trunk is on
Hold).
15-02-06
Multiline Telephone Basic Data Setup – Hold
Key Operating Mode
Set the function of the Multiline Hold key.
0 = Normal (Common)
1 = Exclusive Hold
0