557
Service Code Setup (for Hotel) – Room
Status Change for Own Extension
Customize the room status change for own
extension Service Codes used with the Hotel/
Motel feature (GCD-CP10 must be licensed for
Hotel/Motel).
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
Service Code Setup (for Hotel) – Room
Status Change for Other Extension
Customize the room status change for other
extension Service Codes which are used with
the Hotel/Motel feature (GCD-CP10 must be
licensed for Hotel/Motel).
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
Service Code Setup (for Hotel) – Room
Status Output
Customize the room status output Service
Codes used with the Hotel/Motel feature
(GCD-CP10 must be licensed for Hotel/Motel).
MLT
0 ~ 9,
*
, # Maximum of eight
digits
Service Code Setup (for Hotel) – Hotel Room
Monitor
Customize the hotel room monitor Service
Codes used with the Hotel/Motel feature
(GCD-CP10 must be licensed for Hotel/Motel).
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
Service Code Setup (for Hotel) – Set Hotel
PMS Code Restriction
Customize the set hotel PMS code restriction
Service Codes used with the Hotel/Motel
feature (GCD-CP10 must be licensed for Hotel/
Motel).
MLT
0 ~ 9,
*
, # Maximum of eight
digits
Single Line Telephone Basic Data Setup –
SLT Signaling Type
Select the type of dialing the connected
telephone uses.
For the UNIVERGE SV9100 Wireless
telephones to function correctly, this must be
set to 0. If this option is set for DTMF, after an
outside call is placed, the system cannot dial
any additional digit.
This program change is automatically
performed when the UNIVERGE SV9100
Wireless telephone is registered. When
upgrading software from prior versions, the
previous default of 1 is saved from the prior
database so this option must be changed
manually.
Single Line Telephone Basic Data Setup –
Flashing
Enable/Disable Flash for single line (500/2500
type) telephones.
To Next Page
Loading...
