NEC Univerge SV9100 - Page 681

681
Program
Number
Program Name/Description
Input Data
Default
20-17-01
Operator Extension – Operator’s Extension
Number
Define the extension numbers used by
operators.
Maximum of eight digits
101
20-18-01
Service Tone Timers – Extension Dial Tone
Time
After getting Intercom dial tone, a multiline
terminal user has this time to dial the first digit
of the Intercom call.
0 ~ 64800 seconds
30
21-01-02
System Options for Outgoing Calls –
Intercom Interdigit Time
When placing Intercom calls, an extension user
must dial each digit during this time.
0 ~ 64800 seconds
10
82-01-01
Incoming Ring Tone – Frequency 1
1 = 520Hz
Refer to
(01)
Customize the Intercom ring tone.
2 = 540Hz
Default
3 = 660Hz
4 = 760Hz
Incoming
Ringing Tone
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
82-01-02
Incoming Ring Tone – Frequency 2
Customize the Intercom ring tone.
1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
Refer to Default
Incoming
Ringing Tone
82-01-03
Incoming Ring Tone – Modulation
Customize the Intercom Ring Tone modulation
if desired.
0 = No Modulation
1 = 8Hz Modulation
2 = 16Hz Modulation
3 = Envelope
2
Handsfree Answerback/Forced Intercom Ringing:
Program
Number
Program Name/Description
Input Data
Default
11-11-15
Service Code Setup (for Setup/Entry
Operation) – Enable Handsfree Incoming
Intercom Calls
Customize the enable handsfree incoming
intercom calls used for registration and setup.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
821
11-11-16
Service Code Setup (for Setup/Entry
Operation) – Force Ringing of Incoming
Intercom Calls
Customize the force ringing of incoming
intercom calls used for registration and setup.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
823