NEC Univerge SV9100 - Page 682

682
Program
Number
Program Name/Description
Input Data
Default
20-02-12
System Options for Multiline Telephones –
Forced Intercom Ring (ICM Call Type)
Enable/Disable Forced Intercom Ringing. If
enabled, Intercom calls normally ring. If
disabled, intercom calls voice announce. For
all NEC Cordless telephones, this option must
be enabled since voice announce is not
possible.
0 = Disable (Voice)
1 = Enable (Signal)
0
20-06-01
Class of Service for Extensions
Assign Class of Service (1 ~ 15) for extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-08-10
Class of Service Options (Outgoing Call
Service) – Signal/Voice Call
Turn Off or On an extension ability to force
Handsfree Answerback or Forced Intercom
Ringing for outgoing Intercom calls.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-09-05
Class of Service Options (Incoming Call
Service) – Signal/Voice Call
Turn Off or On an extension user ability to
enable Handsfree Answerback or Forced
Intercom Ringing for their incoming Intercom
calls.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-06
Class of Service Options (Supplementary
Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension user to Manually (0) or
Automatically (1) receive off-hook signals.
This setting is to receive incoming call
signaling information during call queuing.
0 = Off
1 = On
COS 1 ~ 15 = 1
80-01-01
(28)
Service Tone Setup – Tone 28 (Speaker
Monitor Tone)
This tone changes the tone the originator of an
ICM call hears. (The tone cannot be changed
for what is heard by the user when receiving an
ICM call.)
Service Tone #28
Refer to Service
Tone Setup
Defaults,
Program
80-01-01
80-01-02
Service Tone Setup – Basic Tone Number
Define up to 64 Service Tones. Each service
tone is defined by the combination of 32 Basic
Tones.
1 ~ 33
(0 = No Tone)
(33 = Default Time Slot)
1~33
(0 = No Tone)
(33=Default Time
Slot)
Refer to Service
Tone Setup,
Program 80-01-
02