NEC Univerge SV9100 - Page 700

700
Program
Number
Program Name/Description
Input Data
Default
15-05-47
IP Telephone Terminal Basic Data Setup –
Registration Expire Timer for NAT
On a per station basis, this setting defines the
SIP registration expiry timer.
If this value is set to 0, for a NAPT terminal, the
value in Program 84-23-01 is applied.
60 ~ 65535 seconds
0 = Disable
180
15-05-48
IP Telephone Terminal Basic Data Setup –
Subscribe Expire Timer for NAT
On a per station basis, this setting defines the
SIP Subscribe expiry timer.
If this value is set to 0, for a NAPT terminal, the
value in Program 84-23-02 is applied.
60 ~ 65535 seconds
0 = Disable
180
84-26-01
IPL Basic Setup – IP Address
Assign the IP address for each DSP on the
GPZ-IPLE.
xxx.xxx.xxx.xxx
172.16.0.20
84-26-02
IPL Basic Setup – RTP Port Number
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
0 ~ 65534
10020
84-26-03
IPL Basic Setup – RTCP Port Number (RTP
Port Number + 1)
Define the TCP port number for RTCP to use
for each DSP.
0 ~ 65534
10021
In addition to the above programming, define the programming options as required for the system
features.