NEC Univerge SV9100 - Page 727

727
Feature Support Table for Standard SIP Device (Continued)
Feature Name
Standard
SIP
Comments
Single Line Telephones, Analog 500/2500 Sets
No
Softkeys
No
Speed Dial - System/Group/Station
No
Station Hunt
No
Station Message Detail Recording
Yes
Station Name Assignment – User Programmable
No
Station Relocation
No
SV9100 Communications Analyst Enterprise
Yes
SV9100 PoE Gigabit Switch
No
SV9100 UC Suite
No
SV9100 Terminals
No
Synchronous Ringing
No
T1 Trunking (with ANI/DNIS Compatibility)
Yes
Tandem Ringing
No
Tandem Trunking (Unsupervised Conference)
TAPI Compatibility
No
Tone Override
No
Traffic Reports
No
Transfer
Yes
Transferred calls cannot be pulled back once transfer is
initiated.
Trunk Group Routing
Yes
Trunk Groups
Yes
Trunk Queuing/Camp-On
Uniform Call Distribution (UCD)
No
Uniform Numbering Network
Yes
UM8000
Yes
User Programming Ability
Virtual Extensions
No
Limited user customization available.
Voice Call & Signal Switching
Yes
Can only send voice/signal switch.
Voice Mail Integration (Analog)
Yes
Voice Over
No
Voice Over Internet Protocol (VoIP)
Yes
By nature, this is a SIP device.