NEC Univerge SV9100 - Page 75

75
Program
Number
Program Name/Description
Input Data
Default
44-03-02
Dial Analysis Extension Table – ARS/F-
Route Select Table Number (1~250)
When dialed digits match the setting in
Program 44-03-01, select the ARS/R-Route
table number (0 ~ 500) to be used for the Dial
Extension Analysis Table.
0 ~ 500
(ARS/F-Route Table Number)
With Program 44-01 set to 0,
Program 44-05 is checked.
With Program 44-01 set to 1,
Program 44-04 is checked.
0
44-03-03
Dial Analysis Extension Table – ARS/F-
Route Select Table Number (251)
If the received digits are not identified in tables
1 ~ 250, the F-Route selection table number (0
~ 500) defined in table 251 is used.
0 ~ 500
(ARS/F-Route Table Number)
With Program 44-01 set to 0,
Program 44-05 is checked.
With Program 44-01 set to 1,
Program 44-04 is checked.
0
44-03-04
Dial Analysis Extension Table – Next Table
Area Number (252)
If the received digits do not match the digits set
in tables 1 ~ 250, table number 252 is used to
refer to the next Extension Table Area (1 ~ 4) to
be searched.
0 ~ 4
0
44-04-01
ARS/F-Route Selection for Time Schedule
Assign each ARS/F-Route Selection number (1
~ 500) to an ARS/F-Route table number for
each ARS/F-Route time mode. There are eight
time modes for ARS/F-Route Access.
ARS/F-Route Time Mode: 1 ~ 8
ARS/F-Route Table Number = 0
~ 500
0
44-05-01
ARS/F-Route Table – Trunk Group Number
Select the trunk group number to be used for
the outgoing ARS call.
0 ~ 100, 255
0 = No Setting
255 = Extension Call
0
44-05-02
ARS/F-Route Table – Delete Digits
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Enter the number of
digits to be deleted (0 ~ 255) from the dialed
number.
0 ~ 255
(255 = Delete All)
0
44-05-03
ARS/F-Route Table – Additional Dial Number
Table
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Enter the table number
(defined in Program 44-06) for additional digits
to be dialed (0 ~ 1000).
0 ~ 1000
0
44-05-04
ARS/F-Route Table – Beep Tone
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select whether or not a
beep is heard if a lower priority trunk group is
used.
0 = Off (No Beep)
1 = On (Beep)s
0
44-05-05
ARS/F-Route Table – Gain Table Number for
Internal Call
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the gain table
number to be used for internal calls (0 ~ 500).
0 ~ 500
0 = No Setting
0