NEC Univerge SV9100 - Page 76

76
Program
Number
Program Name/Description
Input Data
Default
44-05-06
ARS/F-Route Table – Gain Table Number for
Tandem Connections
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the gain table
number to be used for the tandem call (defined
in Program 44-07).
0 ~ 500
0 = No Setting
0
44-05-07
ARS/F-Route Table – ARS Class of Service
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the Class of
Service to be used for ARS (0~16). Extension
ARS COS is determined in Program 26-04-01.
0 ~ 16
0
44-05-08
ARS/F-Route Table – Dial Treatment
For each ARS/F-Route table (1 ~ 500) assign a
priority number (1 ~ 4). Select the Dial
Treatment to be used (0 ~ 15). The Dial
Treatments are defined in Program 26-03-01.
0 ~ 15
0
44-05-09
ARS/F-Route Table – Maximum Digit
Set the maximum number of digits to send
when using the F-Route.
0 ~ 24
0
44-05-10
ARS/F-Route – CCIS over IP Destination
Point Code
For each ARS/F-Route table (1 ~ 500). Set the
CCIS over IP Destination Point Code
(0 ~ 16367).
0 ~ 16367
0
44-05-11
ARS/F-Route – Network Specified Parameter
Table
For each ARS/F-Route table (1 ~ 500) assign
the priority (1 ~ 4). Assign the Network
Specified Parameter Table (0 ~ 16).
0 ~ 16
0
44-06-01
Additional Dial Table
If an Additional Dial Number Table is entered in
Program 44-05-03, define the additional dial
table (1 ~ 1000) to add digits in front of the
dialed ARS/F-Route number (24 digits
maximum: 1-9, 0 * #, Pause). To enter a wild
card/don’t care digit, press Line Key 1 to enter a
P (pause) symbol.
Maximum of 24 digits Enter:
1 ~ 9, 0, *, #, Pause (press
line key 1 to enter a
pause)
No Setting