NEC Univerge SV9100 - Page 770

770
Program
Number
Program Name/Description
Input Data
Default
84-10-01
ToS Setup – ToS Mode
When Input Data is set to 1, Protocol 7 is
invalid. When Data is set to 2, Protocols 2 ~ 6
are invalid.
0 = Disable (Invalid)
1 = IP Precedence
2 = Diffserv
0
84-10-02
ToS Setup – Priority, IP Precedence
1 = Router queuing priority.
0 ~ 7
0 = Low
7 = High
0
84-10-03
ToS Setup – Low Delay
1 = Optimize for low delay routing.
0 ~ 1
0 = Normal Delay, Low Delay
0
84-10-04
ToS Setup – Wideband (Throughout)
1 = Optimize for high bandwidth routing.
0 ~ 1
0 = Normal Throughput
1 = High Throughput
0
84-10-05
ToS Setup – High Reliability
1 = Optimize for reliability routing.
0 ~ 1
0 = Normal Reliability
1 = Low Reliability
0
84-10-07
ToS Setup – Priority (D.S.C.P. -
Differentiated Services Code Point)
DSCP (Differentiated Services Code Point).
0 ~ 63
0
84-13-01
SIP Trunk CODEC Information Basic Setup –
Number of G.711 Audio Frames
Set the G.711 Audio Frame Number.
1 ~ 4
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
(Profile 1 ~ Profile 2)
2
84-13-02
SIP Trunk CODEC Information Basic Setup –
G.711 Voice Activity Detection Mode
Enable/Disable the G.711 VAD Detection Mode.
0 = Disable
1 = Enable
(Profile 1 ~ Profile 2)
0
84-13-03
SIP Trunk CODEC Information Basic Setup –
G.711 Type
Define the G.711 type.
0 = A-law
1 = -law
(Profile 1 ~ Profile 2)
1
84-13-04
SIP Trunk CODEC Information Basic Setup –
G.711 Jitter Buffer (min)
Set the minimum G.711 Jitter Buffer.
0 ~ 300ms
(Profile 1 ~ Profile 2)
20
84-13-05
SIP Trunk CODEC Information Basic Setup –
G.711 Jitter Buffer (Average)
Set the average G.711 Jitter Buffer.
0 ~ 300ms
(Profile 1 ~ Profile 2)
40
84-13-06
SIP Trunk CODEC Information Basic Setup –
G.711 Jitter Buffer (max)
Set the maximum G.711 Jitter Buffer.
0 ~ 300ms
(Profile 1 ~ Profile 2)
80