NEC Univerge SV9100 - Page 769

769
Program
Number
Program Name/Description
Input Data
Default
21-19-01
IP Trunk (SIP) Calling Party Number Setup
for Extension
Assign the Calling Party Number for each
extension. The assigned number is sent to the
central office when the caller places an
outgoing call. If the Calling Party Number is
assigned by both Program 21-17 and Program
21-18/Program 21-19, the system uses the data
in Program 21-18/Program 21-19.
1 ~ 0, *, # Maximum of 16 digits
(Profile 1 ~ Profile 2)
No Setting
22-02-01
Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
Trunks 1 ~ 400
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
0
44-02-01
Dial Analysis Table for ARS/F-Route Access
– Dial
Set the Dial digits for the Pre-Transaction Table
for selecting ARS/F-Route (eight digits max:
1 ~ 9, 0 * #, @). To enter a wild card/don’t care
digit, press Line Key 1 to enter an @.
Maximum of eight digits.
(Use line key 1 for a ‘Don’t Care’
digit, @)
No Setting
44-02-02
Dial Analysis Table for ARS/F-Route Access
– Service Type
Set the Service Type (0 ~ 3) for the Pre-
Transaction Table for selecting ARS/F-Route.
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
0
44-02-03
Dial Analysis Table for ARS/F-Route Access
– Additional Data
If a Service Type is selected in Program
44-02-02, set the additional data, if required, for
the Pre-Transaction Table for selecting ARS/F-
Route (24 digits max: 1 ~ 9, 0 * #, @). To enter a
wild card/don’t care digit, press Line Key 1 to
enter an @.
1 = Delete Digit = 0 ~ 255
(255: Delete All Digits)
2 = 0 ~ 500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0 ~ 4
(0 = No Setting)
0
44-05-01
ARS/F-Route Table – Trunk Group Number
Assign the trunk group to be used by the ARS/
F-Route Table.
0 ~ 100, 255
0 = No Setting
255 = Extension Call
0
44-05-09
ARS/F-Route Table – Maximum Digit
Input the maximum number of digits to send
when using the F-Route.
0 ~ 24
0