NEC Univerge SV9100 - Page 768

768
Program
Number
Program Name/Description
Input Data
Default
11-01-01
System Numbering – Service Code
Set the system internal (Intercom) numbering
plan. The numbering plan assigns the first and
second digits dialed and affects the digits an
extension user must dial to access other
extensions and features, such as service codes
and trunk codes. If the default numbering plan
does not meet the site requirements, use this
program to tailor the system numbering to the
site.
14-01-24
Basic Trunk Data Setup – Trunk-to-Trunk
Outgoing Caller ID through Mode
Enable/Disable the ability to send the original
Caller ID through when the call is Forward
Off-Premise.
0 = Disable (No)
1 = Enable (Yes)
0
14-05-01
Trunk Group – Trunk Group Number
Assign trunks to trunk groups.
Trunk Port 1 ~ 400 =
Priority 1 ~ 400
Default = Trunks
1 ~ 400 assigned
to trunk group 1
with priorities
equal to the
trunk number.
Trunk 1 = Priority
1 Trunk 400 =
Priority 400.
14-18-05
IP Trunk Data Setup – SIP Profile (SIP Trunk)
Assign each SIP Trunk to either Profile 1 or
Profile 2.
Profile 1
Profile 2
Profile 1
15-03-18
Single Line Telephone Basic Data Setup –
Select Special Terminal
Used for selecting Special terminal type (FAX or
Modem). This setting influences how data is
transmitted via SIP trunk.
Program 15-03-03 must be set to 1 (Special) to
use this feature.
Type:
0 = FAX
1 = Modem
0
21-17-01
IP Trunk (SIP) Calling Party Number Setup
for Trunk
Assign the Caller Party Number for each IP
trunk. The assigned number is sent to the
central office when the caller places an
outgoing call. If the Calling Party Number is
assigned by both Program 21-17 and Program
21-18/ 21-19, the system uses the entry in
Program 21-18/21-19.
1 ~ 0, *, # Maximum of 16 digits
No Setting