NEC Univerge SV9100 - Page 788

788
Program
Number
Program Name/Description
Input Data
Default
10-36-02
SIP Trunk Registration Information Setup –
User ID
Assign the SIP User ID provided by your SIP
Carrier. In most cases this is your 10 digit main
billing number. This field is also used to send
outbound caller ID information when not
programmed on a per station or per trunk basis.
For non-registration and SIP Tie Lines to
another system, you MUST have a USER ID
entered.
Maximum of 32 characters.
(Profile 1 ~ Profile 2)
No Setting
10-36-03
SIP Trunk Registration Information Setup –
Authentication User ID
Define the Authentication USER ID for the SIP
Trunk.
Maximum of 64 characters.
(Profile 1 ~ Profile 2)
No Setting
10-36-04
SIP Trunk Registration Information Setup –
Authentication Password
Define the Authentication Password for the SIP
Trunk.
Maximum of 32 characters.
(Profile 1 ~ Profile 2)
No Setting
10-68-01
IP Trunk Availability – Trunk Type
Assign the trunk type as 1 (SIP).
0 = None
1 = SIP
2 = H.323
3 = CCIS
0
10-68-02
IP Trunk Availability – Start Port
Set the trunk port number to start the
assignment from.
0 ~ 400
0
10-68-03
IP Trunk Availability – Number of Ports
Set the number of ports to assign from the
starting point set in Program 10-68-02.
0 ~ 400
0
15-03-03
Single Line Telephone Basic Data Setup –
Terminal Type
Enter 1 for this option to allow the SIP Station
ports to receive DTMF tones after the initial call
setup. For the Appointment Reminder, always
enter 1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
0
15-03-18
Single Line Telephone Basic Data Setup –
Select Special Terminal
Used for selecting Special terminal type (FAX or
Modem). This setting influences how data is
transmitted via SIP trunk.
Program 15-03-03 must be set to 1 (Special) to
use this feature.
Type:
0 = FAX
1 = Modem
0