899
System Options – DTMF Receive Active
Time
After answering the Tie Line call, the system
attaches a DTMF receiver to the Tie Line for
this time.
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to
extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Incoming Call
Service) – Second Call for DID/DISA/DIL/
E&M Override
Turn Off or On the extension ability to receive a
second call from a DID, DISA, DIL, or tie line
caller.
With this option set to 1, the destination
extension must be busy for a second DNIS caller to
ring through. If the destination extension does not
have a trunk or CAP key available for the second
call and a previous call is ringing the extension but
has not yet been answered, the second caller hears
busy regardless of this program setting.
Class of Service Options for DISA/E&M –
First Digit Absorption (Delete First Digit
Dialed)
For Tie Lines, turn Off or On the ability to
absorb (ignore) the first incoming digit. Use this
to make the tie trunk compatible with
3- and 4-digit Tie Line service. This option does
not apply to DISA.
Class of Service Options for DISA/E&M –
Trunk Group Routing/ARS Access
Turn Off or On a DISA or tie trunk caller ability
to dial 9 for Trunk Group Routing or Automatic
Route Selection (ARS).
Class of Service Options for DISA/E&M –
Trunk Group Access
Turn Off or On a DISA or tie trunk caller ability
to access trunk groups for outside calls (Service
Code 704).
Class of Service Options for DISA/E&M –
Outgoing System Speed Dial
Turn Off or On a DISA or tie trunk caller ability
to use the System Speed Dialing.
Class of Service Options for DISA/E&M –
Operator Calling
Turn Off or On a DISA or tie trunk caller ability
to dial 0 for the telephone system operator.
To Next Page
Loading...
