908
Tie Line Initial Setup – Prepause Time
Selection
Specify the loop open time for a hookflash
signal sent to the Tie Line when the Recall key
on a multiline terminal is pressed. A single line
telephone generates a hookflash to the Tie Line
when a single line telephone hookflash is
assigned.
1 ~ 4
(1 ~ 4 = 0.5 ~ 2.0 seconds)
(5 ~ 15 = 3.0 ~ 13 seconds)
(0 = No Setting)
Tie Line Initial Setup – Tie Line Answer
Detect Time Selection
Specify the time before a SV9100 System
answer (off-hook) is recognized as an answer.
0 ~ 15
(130ms ~ 1950ms)
(0 = No Setting)
Tie Line Initial Setup – Tie Line Release
Detect Time Selection
Specify the before the circuit disconnect
detected on the Tie Line on the distant system
side is recognized as Tie Line release.
0 ~ 15
(130ms ~ 1950ms)
(0 = No Setting)
Tie Line Initial Setup – Incoming Signal
Detect Time Selection
Specify the time after the incoming signal from
another system is detected before the
acknowledge signal is sent out.
[Wink Start]
1 ~ 15
(130ms ~ 1950ms)
(0 = No Setting)
[Delay]
1 ~ 15
(30ms ~ 450ms)
(0 = No Setting)
[Wink Start] 3
(390ms)
[Delay] 3 (90ms)
Tie Line Initial Setup – Loop Off-Guard Time
Selection
Assign the loop off-guard time to prevent noise
that could cause the system to be unable to
answer an incoming Tie Line.
1 ~ 4
(0.5 sec ~ 2.0 seconds)
5 ~ 15
(3 sec ~ 13 seconds)
(0 = No Setting)
Tie Line Initial Setup – Length of Wink
Signal Selection
Specify the time a wink pulse is sent to another
system.
Tie Line Initial Setup – Length of Delay
Signal Selection
Specify the time a delay pulse is sent to another
system.
1 ~ 15
(300 ms ~ 4.5 seconds)
(0 = No Setting)
Tie Line Initial Setup – Incoming Interdigit
Timeout Selection
Specify the time that an address signal is
missing during the incoming call detection
process before an error tone is returned to the
other system.
0 = 8
1 ~ 15
(1 ~ 15 seconds)
To Next Page
Loading...
