NEC Univerge SV9100 - Page 944

944
Program
Number
Program Name/Description
Input Data
Default
20-03-07
System Options for Single Line Telephones
– Trunk Call Dial Forced Sending Start Time
(Forced Dial)
Define the Trunk Call Dial Forced Sending Start
Time (Forced Dial) for single line telephones.
0 ~ 64800 seconds
0
20-06-01
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-13-13
Class of Service Options (Supplementary
Service) – Continued Dialing (DTMF) Signal
on ICM Call
Turn Off or On an extension user ability to use
Continued Dialing, which allows DTMF signal
sending while talking on extension.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-15-01
Ring Cycle Setup – Normal Incoming Call on
Trunk
Define the ring cycle for Incoming Internal calls.
Ringing Cycle = 1 ~ 13
2
20-15-03
Ring Cycle Setup – Incoming Internal Call
Define the incoming internal call ringing cycles
for each ring type.
Ringing Cycle = 1 ~ 13
12
20-15-05
Ring Cycle Setup – DID/DDI
Define the ring cycle for DID/DDI calls.
Ringing Cycle = 1 ~ 13
8
80-03-01
DTMF Tone Receiver Setup – Detect Level
Use Items 11 ~ 32 to set the criteria for dial tone
detection for outgoing ARS calls.
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
Type 1 ~ 5 = 0
80-03-02
DTMF Tone Receiver Setup – Start Delay
Time
Define the start delay time for DTMF Tone
Receiver.
0 ~ 255
(0.25ms ~ 64ms)
Type 1 ~ 5 = 0