951
Guide to Feature Programming
General Purpose Relay Setup – Slot No.
Physical Port of DLCA Sensor Circuit No.
Define which relay circuits (5 ~ 8) on the
PGD(2)-U10 ADP are used for General
Purpose Relays.
Slot No: 0 ~ 24
DCLA Port: 0 ~ 16
Relay No: 0, 5 ~ 8
After each entry, press
Transfer to advance to the next
entry.
GCD-CP10 Hardware Setup – External
Source I/O Selection on GCD-CP10
Define how the I/O ports on the GCD-CP10 are
used.
0 = External MOH (AUX2)/
External Speaker(AUX1)
1 = BGM source (AUX2)/
External Speaker(AUX1)
2 = External MOH (AUX2)/
BGM source (AUX1)
Relationships between AUX
number and Relay number are as
follows:
AUX2 = Relay2
AUX1 = Relay1
Service Code Setup (For Service Access) –
General Purpose Relay
Specify the service code used to toggle the
relay open and closed.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
Programmable Function Keys
Assign function keys for External Paging zones
(19 + zone) and External All Call Page (20). If
required, define a function key for a multiline
terminal to use the general purpose relay (51).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Supplementary
Service) – Paging Display
Turn Off or On an extension user ability to
display paging information.
System Options for Internal/External Paging
– Page Announcement Duration
Set the maximum allowable duration for a
Paging announcement.
Internal Paging Group Settings – Internal
Paging Group Name
Assign name to Internal Paging Groups (i.e.,
Page Zones). The system shows the name you
program on the telephone display.
Maximum of 12 characters.
To Next Page
Loading...
