NEC Univerge SV9100 - Page 980

980
PC Programming
Related Features
Alarm Reports
Direct Inward Dialing (DID)
Guide to Feature Programming
 The items highlighted in gray are read only and cannot be changed.
PC Programming:
Program
Number
Program Name/Description
Input Data
Default
10-12-01
GCD-CP10 Network Setup – IP Address
Assign the IP Address.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
192.168.0.10
10-12-02
GCD-CP10 Network Setup – Subnet Mask
The setting of Subnet Mask is invalid when all
Host Addresses are 0.
If the network section is:
0,
127,
128.0,
191.255,
192.0.0,
223.255.255
The setting of Subnet Mask is invalid.
128.0.0.0 | 192.0.0.0 | 224.0.0.0
|240.0.0.0 | 248.0.0.0 | 252.0.0.0
|254.0.0.0 | 255.0.0.0
|255.128.0.0 | 255.192.0.0
|255.224.0.0 | 255.240.0.0
|255.248.0.0 | 255.252.0.0
|255.254.0.0 | 255.255.0.0
|255.255.128.0 | 255.255.192.0
|255.255.224.0 | 255.255.240.0
|255.255.248.0 | 255.255.252.0
|255.255.254.0 | 255.255.255.0
|255.255.255.128
|255.255.255.192
|255.255.255.224
|255.255.255.240
|255.255.255.248
|255.255.255.252
|255.255.255.254
|255.255.255.255
255.255.0.0
10-12-03
GCD-CP10 Network Setup – Default
Gateway
Assign the default gateway IP address for the
GCD-CP10.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
11-15-14
Service Code Setup, Administrative (for
Special Access) – Modem Access
Assign the service code to be used to access
the internal modem on the GCD-CP10.
No Setting
22-02-01
Incoming Call Trunk Setup
Define the service type for the trunk intended to
access the internal modem as 4:DIL.
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0