NEC Univerge SV9100 - Page 981

981
Program
Number
Program Name/Description
Input Data
Default
22-07-01
DIL Assignment
Assign the Modem Access service code set in
Program 11-15-14 as the destination extension
for the DIL trunk for modem access.
For this selection to work, set Program
22-02-01 to 4 (DIL).
Day/Night Modes (1 ~ 8):
Extension Number (maximum of
eight digits)
Pilot Number
No Setting
90-02-01
Programming Password Setup – User Name
Set the system passwords.
Maximum of 10 characters.
90-02-02
Programming Password Setup – Password
Configure the administrator accounts that are
used when connecting to the KTS via PCPro/
WebPro.
If using PCPro, these are the accounts that are
used to connect.
If using WebPro, these are the accounts that
are used to login.
Maximum of eight digits.
90-02-03
Programming Password Setup – User Level
Set the system password user levels.
0 = Prohibited User
1 = MF (Manufacturer Level)
2 = IN (Installer Level)
3 = SA (System Administrator
Level 1)
4 = SB (System Administrator
Level 2)
5 = UA (User Programming
Level 1)
90-26-01
Program Access Level Setup – Maintenance
Level
Define access levels to each program. This
program defines which administrator accounts
in Program 90-02 can access the program. If a
program is not accessible, it does not appear in
PCPro/WebPro.
1 = MF Level
2 = IN Level
3 = SA Level
4 = SB Level
Refer to the
Level indication
for each
individual
program (located
in the upper left
corner at the
beginning of
each program).
90-28-01
User Programming Password Setup –
Password
Use to set the password to enter the user
programming mode.
Maximum of eight digits
Fixed four digits
1111