NEC Univerge SV9100 - Page 995

995
Required Component(s)
None
Related Features
Call Forwarding
Central Office Calls, Placing
Do Not Disturb
Line Preference
Prime Line Selection
Programmable Function Keys
Single Line Telephones, Analog 500/2500 Sets
Transfer
InMail
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
14-01-09
Basic Trunk Data Setup – Private Line
Determine if a trunk should be used as a
Normal or Private line.
A Private Line reserves a trunk for a multiline
terminal for placing and answering calls. A user
with a Private Line always knows when important
calls are for them. Additionally, the user has their
own trunk for placing calls that is not available to
others in the system.
0 = Disable Private Line
(Normal)
1 = Enable Private Line (Private
Line)
0
14-07-01
Trunk Access Map Setup – Trunk Port
Number
Assign Private Line to the Private Line Access
Map (refer to Program 15-06 in this section).
Use option 5 for Incoming, option 7 for Both
Ways and option 4 for Outgoing. In all other
Access Maps, assign option 3 to the Private
Line.
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on
Hold
4 = Outgoing access and access
when trunk on Hold
5 = Incoming access and access
when trunk on Hold
6 = Incoming and Outgoing
access
7 = Incoming access, outgoing
access and access when trunk
on Hold
Trunk Access Maps: 1 ~ 400
Access Maps
1 ~ 400 = Trunk
Ports 1 ~ 400
assigned with
option 7 access
(incoming and
outgoing access
and access
when trunk is on
Hold).