RFL Electronics GARD 8000

Need help?

Do you have a question about the RFL Electronics GARD 8000 and is the answer not in the manual?

Summary

NOTICE

WARRANTY

SECTION 3. TECHNICAL DATA

3.1 SYSTEM SPECIFICATIONS

3.3 CURRENT DIFFERENTIAL SPECIFICATIONS

SECTION 4. INSTALLATION AND COMMISSIONING

4.2 UNPACKING

4.3 MOUNTING

4.5 CONNECTIONS

Details on making electrical connections to the GARD 8000 chassis.

4.6 COMMISSIONING PROCEDURES

Step-by-step instructions for setting up and verifying the GARD 8000 system.

SECTION 5. SYSTEM USER INTERFACE

5.1 WEBSERVER

5.2 ETHERNET ACCESS

5.6 PASSWORDS AND SECURITY

Covers user authentication, password management, and security settings.

SECTION 7. CHASSIS CONFIGURATION SETTINGS

7.2 MODULE SETTINGS

Guides the user through configuring individual modules within the chassis.

7.4 ALARM CONFIGURATION

Details how to configure and manage system alarms.

7.6 SYSTEM LOGIC CONFIGURATION

Covers the setup of system logic, including input/output mapping and options.

SECTION 8. SYSTEM LOGIC

8.3 LOGIC CONFIGURATION

Explains how to configure system logic, including input/output mapping and options.

SECTION 9. TELEPROTECTION

SECTION 10. POWER LINE CARRIER

SECTION 11. TESTS AND DIAGNOSTICS

11.2 INPUT MODULE TEST

Instructions for testing input modules.

11.3 OUTPUT MODULE TEST

Instructions for testing output modules.

11.7 CURRENT DIFFERENTIAL RELAY TEST

Provides instructions for testing the Current Differential Relay.

SECTION 13. CURRENT DIFFERENTIAL RELAY

13.3 RELAY SETTINGS

Covers various settings for the Current Differential Relay.

SECTION 14. ETHERNET TPS MODULE

14.2 INSTALLATION

Instructions for installing the Ethernet TPS Module.

14.3 CONFIGURATION

Covers the configuration of the Ethernet TPS Module.

SECTION 15. GARD METERING MODULE

15.3 WEB PAGE SET-UP

SECTION 16. GARD DNP3 CONFIGURATION AND SNMP TRAP AGENT

16.3 DNP3 WEB PAGE SET-UP

16.7 PROCEDURE FOR LOADING MIB’S TO THE GARD 8000