Tests and Diagnostics
GARD 8000 SYS RFL Electronics
February 14, 2011 11-48 973.334.3100
Send checkback Code
Sends the selected checkback code to the far end as follows: 1–16, or none.
Send Hard Carrier Request
Sends the selected hard carrier request to the far end.
Checkback tests Count
Indicates the total checkback test count.
Checkback Pass count
Indicates the total checkback pass count.
Checkback Fail count
Indicates the total checkback fail count.
Stop 1 Counter
Indicates the Block 1 Receive Count.
Stop 2 Counter
Indicates the Block 2 Receive Count.
Start 1 Counter
Indicates the Start 1 Key Count.
Start 2 Counter
Indicates the Start 2 Key Count.
Block RX Counter
Indicates the Block RX Count.
Reserve Counter
Indicates the Reserve Key Count.
Calibrate RPM
Calibrates the Reflected Power Meter as follows:
1) No: (does nothing)
2) Gain: calibrates the RPM gain
3) DC: calibrates the RPM DC offset.
Follow the steps listed on the webpage.
Calibrate Tx Level
When box is checked, the TX Level Meter is calibrated.
Follow the steps listed on the webpage.
11.7 CURRENT DIFFERIENTIAL RELAY TEST
From the pull-down menu select “System Test.” Then click on Current Diff Relay to go to the
Current Diff Test web page as shown in Figure 11-25.
To Next Page
Loading...