GARD 8000 SYS RFL Electronics
November 28, 2017 xxii (973) 334-3100
WARNING!
ON INITIAL INSTALLATION, ENSURE THAT ALL MODULES ARE FULLY
SEATED INTO CONNECTORS BEFORE POWERING ON UNIT.
CAUTION
THE GARD 8000 CONTAINS STATIC SENSITIVE DEVICES. PERSONS
WORKING ON THIS EQUIPMENT MUST OBSERVE ELECTRO STATIC
DISCHARGE (ESD) PRECAUTIONS BEFORE REMOVING THE FRONT COVER
OR WORKING ON THE REAR OF THE CHASSIS. AS A MINIMUM YOU MUST
DO THE FOLLOWING: USE ANTI-STATIC DEVICES SUCH AS WRIST STRAPS
AND FLOOR MATS, AND LEAVE MODULES IN THEIR ANTI-STATIC BAGS
UNTIL THEY ARE READY TO BE INSTALLED.
WARNING!
YOUR GARD 8000 TERMINAL MAY BE EQUIPPED WITH FIBER OPTIC
INPUT/OUTPUT MODULES THAT HAVE FIBER OPTIC EMITTER HEADS.
FIBER OPTIC EMITTER HEADS USE A LASER LIGHT SOURCE THAT
PRODUCE INVISIBLE RADIATION. FIBER OPTIC COMMUNICATION
SYSTEMS ARE INHERENTLY SAFE IN NORMAL OPERATION BECAUSE ALL
RADIATION IS CONTAINED IN THE SYSTEM. IT IS POSSIBLE DURING
MAINTENANCE TO EXPOSE THE RADIATION BY REMOVING OR BREAKING
THE FIBER. STARING DIRECTLY INTO THE LIGHT BEAM MAY RESULT IN
PERMANENT EYE DAMAGE AND/OR BLINDNESS. NEVER LOOK DIRECTLY
INTO THE LIGHT BEAM AND BE CAREFUL NOT TO SHINE THE LIGHT
AGAINST ANY REFLECTIVE SURFACE.
THE LASER SOURCE IS A CLASS I LASER PRODUCT WHICH COMPLIES
WITH APPLICABLE FDA, OSHA AND ANSI STANDARDS.
For PLC Applications:
CAUTION
When setting J24 to ‘CONNECT’
Do not install jumpers J27 and J28
To Next Page
Loading...