Module Descriptions
GARD 8000 SYS RFL Electronics
April 23, 2015 6-49 973.334.3100
Table 6-21. GARD Module Level Alarms, Continued…
255 (E1) or 192 (T1) consecutive 0’s
have been detected.
2 or more bi-polar violations/sec.
2 or more CRC errors/sec.
2 or more frame errors/sec.
The transmitter has failed.
The signal to noise ratio is too low.
The logic bus disable bit is set.
Active if the carrier is forced to any
state.
The checkback sequence has failed.
Active if the receive level is too low.
Active if the Reflected Power Meter
has failed.
To Next Page
Loading...