RFL Electronics GARD 8000 - Page 249

Chassis Configuration Settings
GARD 8000 SYS RFL Electronics
April 1, 2012 7-13 973.334.3100
7.2.5.2 C37.94 SHORT HAUL FIBER INTERFACE
When a C37.94 Comms Module is installed, a Configuration Web page similar to the one shown in
Figure 7.6 will be displayed. The parameters shown in paragraph 7.2.5.1 may not apply to all Comms
Modules. Those parameters that do not apply to a particular Comms Module will be blank.
7.2.5.3 G.703 DIGITAL INTERFACE
When a G.703 Digital Interface Comms Module is installed, a Configuration Web page similar to the
one shown in Figure 7.6 will be displayed. The parameters shown in paragraph 7.2.5.1 may not apply
to all Comms Modules. Those parameters that do not apply to a particular Comms Module will be
blank.
7.2.5.4 LONG HAUL FIBER OPTIC INTERFACE
When a Long Haul Fiber Comms Module is installed, a Configuration Web page similar to the one
shown in Figure 7.6 will be displayed. The parameters shown in paragraph 7.2.5.1 may not apply to all
Comms Modules. Those parameters that do not apply to a particular Comms Module will be blank.
7.2.5.5 T1/E1 ELECTRICAL INTERFACE
When a T1/E1 Electrical Interface Comms Module is installed, a Configuration Web page similar to
the one shown in Figure 7.6 will be displayed. The parameters shown in paragraph 7.2.5.1 may not
apply to all Comms Modules. Those parameters that do not apply to a particular Comms Module will
be blank.
7.2.5.6 RS-232 ASYNC COMMS INTERFACE
When an Async Comms Module is installed, a Configuration Web page similar to the one shown in
Figure 7.2 will appear. As the Async Comms Module is an Auxiliary Interface, the Controlling
Communication Interface (or head) must be clicked on the Configuration Web page to access Timeslot
Configurations. Refer to Section 7.2.10.1 for Time Slot Settings. The Async Module can only be
installed in the chassis rear top locations.